Beurer medical BM 48 Gebrauchsanweisung Seite 32

Attaching the cuff
Place the cuff on to the bare left up-
per arm. The circulation of the arm
must not be hindered by tight cloth-
ing or similar.
The cuff must be placed on the up-
per arm so that the bottom edge is
positioned 2 – 3 cm above the elbow
and over the artery. The line points to
the centre of the palm.
Now tighten the free end of the cuff,
but make sure that it is not too tight
around the arm and close the hook
and loop fastener. The cuff should be
fastened so that two fingers fit under
the cuff.
Now insert the cuff line into the con-
nection for the cuff connector.
Important: The unit may only be op-
erated with the original cuff. The cuff
is suitable for an arm circumference of 22 to 36 cm.
All manuals and user guides at all-guides.com
A larger cuff for upper-arm circumferences of 35 to 44 cm
can be obtained from specialist retailers or from the service
address using order number 163.387.
Adopt the correct posture
• Before every measurement, relax for about five minutes.
• You can take the measurement while sitting or lying. Make
• To take your blood pressure, make sure you are sitting com-
• To avoid falsifying the measurement, it is important to remain
Selecting memory
• Switch on the blood pressure monitor with the START/STOP
• Select the desired user memory (
32
Otherwise deviations can occur.
sure that the the cuff is at heart level.
fortably with your arms and back leaning on something.
Do not cross your legs. Place your feet flat on the ground.
still during the measurement and not to speak.
button .
function buttons -/+.
or ) by pressing the