Overmax X-bee drone 9.5 fold Bedienungsanleitung Seite 32

Functions
1.
Flight mode selection
Change setting of the GPS switch (A, B, fig. 14): OFF – fixed altitude mode, ON – GPS mode. The
icon
EN
2.
Camera angle adjustment knob
Use the knob to change the camera angle (fig. 15, 16).
3.
Photo / video
Press the key
once. Hold this key to record a video. The icon on the display will start flashing slowly. Press
the key again to end the video.
NOTE! Photos and videos will not be saved if there is no TF memory card in the device.
4.
Quick take-off / landing
Press the key on the controller (fig. 18), and the drone will automatically take off and stop
at the height of 1,5 meters.
Press the same key again to make the drone land. Press any key to leave the automatic landing
mode.
5.
Return
Press the key
The controller will emit a distinctive sound. Press the key again to cancel the procedure.
6.
Low battery warning in the controller
When the icon
it means that the controller's battery is low (fig. 20). Please replace batteries.
7.
Signal strength indicator
The icon
If the icon shows a weak and strong signal (
searching for the signal.
If the icon shows a weak signal (
the drone storage battery has been taken out.
NOTE! To make the signal as strong as possible, make sure the drone flies above the controller
and that there are no obstacles between the controller and drone (fig. 21).
8.
Headless mode
The headless mode can be activated in the mobile application. In this mode, the direction
of the drone corresponds to the direction of the stick on the controller, irrespective of the
direction of the frontal side of the device.
on the controller displays the current flight mode.
on the controller to take a picture (fig. 17). The icon
on the controller (fig. 19) to cause the drone to return to the saved spot („home").
shows up on the display and the controller starts emitting a permanent sound,
shows strength of the signal received by the controller from the drone (fig. 20).
) alternately, it means that the controller is
), it means that the controller is too far from the drone, or
on the display will flash