Overmax X-bee drone 9.5 fold Bedienungsanleitung Seite 29

If the drone is only a meter above the ground, its speed must not exceed 5 m/s. If it is 2
meters above the ground, it should not be faster than 14 m/s.
•
Keep sensors clean.
•
This system works properly only if the drone is at the maximum height of 3 m.
•
Fly in well-illuminated areas above elements with clear textures to make sure drone sensors
can properly collect information about the location of the product.
Drone status indicator (A, fig. 4)
Drone status
Rear LED flashes fast in yellow.
Rear LED glows constantly in yellow.
Rear LED glows constantly in green.
Rear LED flashes fast in green.
Rear LED flashes in yellow.
Rear LED flashes in green.
Rear LED flashes slowly in red.
Rear LED flashes fast in red.
Rear LED flashes once in red every 1,5
sec.
Rear LED flashes twice in red every 1,5
sec.
Rear LED flashes thrice in red every 1,5
sec.
Rear LED flashes four times in red every
1,5 sec.
Return home
Thanks to the return home function, the drone can return to the last saved spot („home").
There are three modes in this function: return home, emergency return, and return on
low battery.
Description
The drone has not connected to the
controller.
No GPS signal.
Strong GPS signal, the drone is ready to
enter GPS mode.
The drone is calibrating the gyroscope.
The drone is in the horizontal compass
calibration mode.
The drone is in the vertical compass
calibration mode.
The drone battery is low, 16% left.
The drone battery is low, 12% left.
Gyroscope issue.
Barometer issue.
Compass issue.
GPS issue.
EN