Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
Before the flight, please place the device in the open and flat area. Do not touch the gimbal
after you have started the drone.
The gimbal contains precise pieces which can get damaged in case of impact of external forces,
which may affect its operation. Carefully handle the gimbal.
Keep the gimbal clean and away from potential sources of dirt, sand, stones, etc., due to
blocking risk.
Placing the drone on an uneven surface or grass, you expose the gimbal to impact and damage.
Do not add any elements to the gimbal. It may affect operation of the device, or even cause
the motor to burn.

Storage battery

Before the first use, please charge the storage battery completely. Make sure you use a USB
power cable (supplied). The charging time is about 180 minutes.
Low battery: one bar on the storage battery flashes, other remain inactive.
Charging: one of the bars on the storage battery flashes, other bars show a current battery
status.
Full battery: all bars on the storage battery glow constantly.
Recommended adapter: 5V
the adapter 5V
2A.
How to assemble and disassemble propellers
1.
Assembly
Propellers are marked as „A" and „B" – during assembly, pay special attention to this marking.
Assemble propellers marked as A and B on corresponding motors (fig. 10).
Tighten up two screws with the use of a screwdriver in a clockwise direction (fig. 11).
2.
Disassembly
Unscrew two screws with the use of a screwdriver (fig. 12), in an anti-clockwise direction. Then
remove the propeller from the device (fig. 13).
NOTE!
Make sure the propellers which rotate in a clockwise and anti-clockwise direction have been
properly installed. In case of wrong installation, the drone will not fly properly and may get
damaged.
Propellers have sharp edges, please carefully handle them due to cutting risk.
Please use only propellers which have been supplied or purchased directly from the
manufacturer.
2A (fig. 9). The aforesaid information is based on use of
EN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis