Overmax X-bee drone 9.5 fold Bedienungsanleitung Seite 26

How to switch the drone on and connect it to the remote control
1.
Press and hold the lock key ( ), and then activate the controller by sliding the on/off
switch (fig. 28). The controller will emit a sound. The signal indicator on the display will
start flashing. It will mean the controller is ready for pairing.
EN
2.
Activate the drone by pressing the on/off switch for three seconds (fig. 29). The drone
will emit a sound and the rear LED will go on. The signal indicator on the display will stop
flashing – it will mean the end of pairing.
Connecting the remote control to the drone is a one-time operation and not required for another
use. You can connect the remote control to the drone only if the controller is not connected to
any other drone. If there are a few kinds of drone and controller in one place, pairing must be
performed one after another for each set to avoid wrong pairing.
How to calibrate the gyroscope
NOTE: the drone has already been calibrated. It is not necessary to recalibrate it, unless you
experience take-off difficulties.
After connecting to the remote control, place the drone on a flat and horizontal surface, and
then point both sticks on the controller at the bottom left corner (fig. 30). When the LED light
stops flashing fast, it will mean the calibration is finished.
How to calibrate the compass
NOTE: The compass calibration must be preceded by the gyroscope calibration. The calibration
must be performed before every flight and also after replacing batteries into new or after
inserting it into the product.
After you switch it off and back on, the drone automatically enters the compass calibration mode.
To enter the compass calibration mode, point two sticks on the controller at the bottom right
corner (fig. 31).
1. Horizontal calibration
The rear LED in the horizontal calibration mode will flash alternately in yellow. Hold the drone
and revolve horizontally on its axis about three times. When the calibration is correct, the LED
will start flashing in green (fig. 32).
2. Vertical calibration
Hold the drone vertically (with the camera facing upwards) and rotate it on its axis about three
times. When the calibration is correct, the LED will glow constantly (fig. 33).
NOTE!
•
Make sure the GPS signal is strong (at least 7 satellites) and flight takes place in a safe space.
•
Do not calibrate the compass in a strong magnetic field.