Safety Devices; General Safety Instructions; Electrical Safety - Zipper Maschinen ZI-ZWM100 Betriebsanleitung

12.3 Safety devices

The machine is equipped with the following safety devices:

12.4 General safety instructions

To avoid malfunctions, damage and health hazards when working with the machine, the
following points must be observed in addition to the general rules for safe working:
• Before start-up, check the machine for completeness and function. Only use the machine if
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
• Choose a level, vibration-free, non-slip surface for the installation location.
• Ensure sufficient space around the machine!
• Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
• Ensure a clean working environment.
• Only use perfect tools that are free of cracks and other defects (e.g. deformations).
• Remove tool keys and other adjustment tools before switching on the machine.
• Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
• Check the strength of the machine connections before each use.
• Never leave the running machine unattended.
• The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the hazards arising from this work.
• Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
• When working on the machine, never wear loose jewellery, loose clothing, ties or long,
open hair.
• Hide long hair under hair protection.
• Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection and gloves).
• Always work with care and the necessary caution and never use excessive force.
• Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
• Do not overload the machine!
• Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work
on the machine, wait until all tools or machine parts have come to a complete standstill
and secure the machine against unintentional restarting.
• Do not work on the machine if it is tired, not concentrated or under the influence of
medication, alcohol or drugs!

12.5 Electrical safety

• Make sure that the machine is earthed.
• Only use suitable extension cables.
• Only use extension cables that are suitable for outdoor use.
• Never use longer cables than necessary.
• Never leave the cable rolled up on the reel when starting the machine.
• Ensure that cables lying on the ground are well marked.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ZWM100 / ZI-ZWM120
The machine is equipped with a safety switch, which switches off
•
the motor as soon as the protective grille is opened.
SAFETY
20