Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-SP 18 LL Li Originalbetriebsanleitung

All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.

6. Operation

You can put the equipment into operation after
you have thoroughly read the installation and ope-
rating instructions. Pay attention to the following
points:
•
Make sure that the equipment is set up se-
curely.
•
Check that the discharge line is fitted cor-
rectly.
•
Lower the pump into the well or shaft using a
securing cable, or hang it inside the rainwater
barrel.
•
The pump will start automatically after you
have pressed the selector switch (7) in the
corresponding pump mode.
•
Take care that the pump does not run dry.
•
To switch off the pump, press the pump mode
selector switch so that it is in "0" position.
Switching on the pump
The pump has a pump mode selector switch (7)
on the battery box (6).
Mode "I": Dry-run safeguard
Set the pump mode selector switch (7) to "I". The
pump has a dry-run safeguard when pump mode
is activated. The pump will be switched off auto-
matically if no liquid medium is detected for lon-
ger than 20 seconds. The dry-run safeguard has
tripped. The pump will make no further priming
attempts. Set the pump mode selector switch to
"0" in order to reset the pump.
Anl_GE_SP_18_LL_Li_SPK13.indb 19 Anl_GE_SP_18_LL_Li_SPK13.indb 19
GB
Mode "II": No dry-run safeguard
Set the pump mode selector switch (7) to "II".
When the pump is used in shallow suction mode,
the dry-run safeguard might trip if the fl ow rate
is too low. To use the pump without the dry-run
safeguard, select mode "II". This will deactivate
the dry-run safeguard and the pump will run con-
tinuously. – Caution! Take care that the pump
does not run dry; operate the pump only under
supervision.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
•
Always pull out the battery pack before star-
ting any cleaning work.
•
For mobile applications, the equipment
should be cleaned with clear water after every
usage.
•
Use a water jet to remove any lint or fibrous
particles that may have become trapped in
the housing.
•
Remove sludge from the shaft bottom and
clean the shaft walls every 3 months.
7.1 Cleaning the paddle wheel
If a lot of deposits collect in the housing, the bot-
tom part of the equipment must be dismantled as
follows:
1. Disconnect the intake cage from the housing.
2. Clean the paddle wheel with clear water. Im-
portant! Do not put down or rest the equip-
ment on the paddle wheel!
3. Assemble in reverse order.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 19 -
27.07.2021 14:55:39 27.07.2021 14:55:39