Troubleshooting - Hendi PROFI LINE 208533 Gebrauchsanweisung

Technical specification
Item no.
Operating voltage and frequency
Rated input power
Capacity
Brewing time
Brewing temperature
Temperature after 6 hours on warming plate
Coffee filters
Dimension
Glass decanter capacity
Remark: Technical specification is subjected to change without prior notification.

Troubleshooting

If the machine does not function properly, please check the below table for the solution. If you are still
unable to solve the problem, please contact the supplier/service provider.
Problem
The is pressed but it does not
light up.
RED indicator lamp at the front
EN
lower side lights up.
The is pressed and it does
light up but no function.
Appliance works, but water flow
is sometimes interrupted for
more than five minutes.
A fuse in the fuse box blows
when the appliance is turned on.
Empty the appliance (no water can remain in the appliance) before it is repaired. If in doubt, always
contact your supplier!
8
Possible cause
1. Appliance is not plugged in
properly.
2. The is broken.
1. Temperature safety device
is activated due to abnormal
operation.
2. Water level sensor is broken.
1. Heating element is broken.
2. Temperature safety device is
damaged.
1. Relay is broken.
2. Temperature safety device is
damaged.
Short circuit.
208533
230V~ 50-60Hz
2020W
maximum 100 cups / hour
1.8 litres / 5 minutes
93°~96°C
max. 80°C
Ø 25cm (110/250 mm)
204x380x(H)425 mm
1.8 litres
Solution
1. Insert plug into socket.
2. Contact your supplier
for a new switch.
Contact your supplier.
Contact your supplier.
Contact your supplier.
Contact your supplier.