This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
The individual channels and their features are listed under DMX-protocol.
DMX mode
Press the MODE button until the display shows Channel Mode:03. Confirm by pressing ENTER.
DMX-protocol
Control-channel 1 – Focus
Value
000 - 255 Focus movement (8bit)
Control-channel 2 – Strobe
Value
000 - 031 LED off
032 - 095 Linear strobe effect with increasing speed
096 - 159 Pulse strobe effect with increasing speed
160 - 223 Random strobe effect with increasing speed
224 - 255 LED on
Control-channel 3 - Dimmer
Value
000 - 255 Intensity 0 to 100%
Characteristic
Characteristic
Characteristic
31/34
00092680, Version 1.0