Dometic Waeco PerfectPower PP402 PAD Bedienungsanleitung Seite 24

General safety instructions
 The inverter may not be installed in a dusty environment.
 Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
 If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
Electrical cables
 If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or wire bushings to prevent damage.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the DC cable in the same duct.
 Fasten the cables securely.
 Lay the cables so that they cannot be tripped over or damaged.
2.3 Operating the appliance safely
!
WARNING!
Note the following basic safety information when using electrical
devices to protect against:
 Electric shock
 Fire hazards
 Injury
 Do not connect any appliances with a higher power requirement than
350 watts.
Note when connecting devices with an electrical drive (such as power
drills and refrigerators), that they often require more power than is
indicated on the type plate.
 Do not operate the device to make coffee while you're driving.
 Do not operate the device near gas or flammable material; the surface
temperature can reach up to 60 °C.
 Operate the device only if you are certain that the housing and the cables
are undamaged.
24
PP402 PAD, PP404 PAD
EN