Connecting And Starting Up - BIAX SRD/H 3-85/2 Originalbetriebsanleitung

Operating Manual for Pneumatic Straight/Angle Grinder
Do not pull the grinder back
when grinding!
Fig. 1: Connecting to the air supply duct

Connecting and Starting Up

Connection of straight/angle grinder
Only connect the compressed air
supply when the grinding tool
has been clamped in the collet
and the valve is switched off.
The BIAX pneumatic straight/angle grinder may
only be operated using clean, dry air! Therefore,
connect the device to a maintenance unit equipped
with a water separator.
The maintenance unit should be installed as near
as possible to the grinder (s
grinder, s Fig. 3:).
ee X F i g. 3 :
O il-lubricated grinder:
U

Prior to connection, blow through the
pressure hose to clear any soiling.

Connect the grinder (A) to the maintenance
unit (D1 - D3) together with the hose unit
(B) and one-hand coupling (C) (see Fig.
2:).

Mount the maintenance unit (D1 - D3) in
the following sequence: water separator
(D1) - pressure regulator (D2) - oil mister
(D3).

Adjust the maintenance unit so that 2-3
drops of oil per minute are added to the air.
B
A
Fig. 2: Connection for oil-lubricated grinder
BA-NR.: 001 580 302
. Fig. 2:, for oil-free
ee X
D2
C
D1
D3
17 von 31
Only pneumatic oil should be used (thin lubricating
oil). You can also order BIAX special oil using our
catalogue.
O il-free grinder:
U

Prior to connection, blow through the
pressure hose to clear any soiling.

Connect the grinder (A) to the filter
pressure reducer (D) with water separator
together with the hose unit (B) and one-
hand coupling (C) (see Fig. 3:).

Set an operating pressure of max. 6 bar at
the filter pressure reducer.

Alternatively, a commercially available
maintenance unit can also be connected to
the filter pressure reducer. Do not fill any
oil into the oil mister when connecting!
Fig. 3: Connection for oil-free grinder
Filter pressure reducer
The air from compressed-air systems is usually
contaminated and has accumulated moisture.
A filter pressure reducer with water separator
should therefore be connected between the
compressed air system and the tool. This not only
controls the operating pressure but cleans and
drains the compressed air.
This thereby increases the benefit and lifetime of
the Biax pneumatic angle grinder.
You can select a suitable filter pressure reducer
from our catalogue.
V06.2021