HIKMICRO G-Serie Kurzanleitung Seite 4

Component
Navigation Button
Laser Button
Lens Sheet Button
Back Button
Focus Knob
Trigger
Autofocus
Cable Interface
3. Charge Device
After the device starts up, the OSD (on-screen display) shows the battery status. When the battery is low, charge
the device and ensure it works properly.
For the first charge, charge the device for 10 hours when the device is turned on.
Note：

The built-in cell battery that powers the real time clock (RTC) of the device may drain during longtime
transportation or storage. It is recommended to recharge the RTC battery for the wellfunctioning of the
device clock.
 To fully charge the RTC battery, the following requirements should be met:
a) The rechargeable lithium batteries should be installed on the device.
b) The device should keep working for more than 10 hours before shutting down.
3.1 Charge Device via Cable Interface
Steps
1. Lift the cover of interface.
2. Plug in the cable, and charge the device.
3.2 Charge Device via Charging Base
Menu Mode:
Press , , , and  to select parameters.


Press OK to confirm.
Non-Menu Mode:
 Press  to turn on/off the LED light supplement.
 Press  to start digital zoom.
Hold the button to turn on laser, and release the button to turn off laser.
Cover the lens to perform the correction.
Exit the menu or return to previous menu.
Adjust lens focal length.
Pull the trigger to capture or scan the QR code.
Hold the trigger to record videos.
Pull the trigger to turn on/ off autofocus function.
Charge the device or export files with supplied cable.
Function
2