Operating Instructions; Declaration Of Conformity; Safety Instructions - IKA RET basic Betriebsanleitung

Contents
Declaration of conformity
Safety instructions
Unpacking
Correct use
Assembling the stand
Operation
Setting the operating mode
Er 5
Setting the safety temperature limit
Setting the temperature control mode
Maintenance
Accessories
Error codes
Technical data
Warranty

Declaration of conformity

We declare under our sole responsibility that this product is in compliance
with the regulations 2014/35/EU and 2014/30/EU and conforms to the
standards or standardized documents EN 61010-1, EN 61010-2-010 and
EN 61326-1.
14
EN
Page For your protection
• Read the operating instructions in full before starting up and follow the
14

safety instructions.

14
• Keep the operating instructions in a place where they can be accessed by
16
everyone.
16
• Ensure that only trained staff work with the appliance.
16
• Follow the safety instructions, guidelines, occupational health and safety
17
and accident prevention regulations.
18
• Socket must be earthed (protective ground contact).
18
• Caution - Magnetism! Effects of the magnetic field have to be taken into
19
account (e.g. data storage media, cardiac pacemakers ...).
19
• Risk of burns! Exercise caution when touching the housing parts and the
20
heating plate. The heating plate can reach temperatures in excess of 340
20
°C. Pay attention to the residual heat after switching off.
21
• Ensure that the mains power supply cable does not touch the heating base
22
plate.
23
• Wear your personal protective equipment in accordance with the hazard
category of the media to be processed. Otherwise there is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustible gases.
• Set up the appliance in a spacious area on an even, stable, clean, nonslip,
dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for damage each time you
use them. Do not use damaged components.
• Gradually increase the speed.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the container moves on the base plate.
• Caution! Only process and heat up any media that has a flash point higher
than the adjusted safe temperature limit that has been set (50 to 360 °C).
Safety instructions