Explanation Of Terms - Assa Abloy MSL mFlipLock basis 23421 Montage- Und Bedienungsanleitung

No. Term
– Escape route door
function/panic
function
– Inside handle
– Outside handle
– Rebate gap
1 Closing latch
2 Bolt
3 Cylinder screw
mount
4 Faceplate
5 Lock follower /
latch pin
6 Lock case
7 Cylinder recess
A Backset
B Centres
(distance)
C Deadbolt throw
EN
32
All manuals and user guides at all-guides.com

Explanation of terms

Explanation of term
Doors with an Escape route door function can be opened at any time in the escape direction (usually
from the inside) using the door handle, even when the door is locked. The doors are equipped with an
escape route door fitting (e.g. a panic touch bar) in the escape direction.
The door handle in the escape direction (usually from the inside).
The door handle in the opposite direction to the escape direction (usually from the outside).
The Rebate gap is the distance between the faceplate and strike plate (Fig. 3).
The latch is retracted by the lever handle or the knob/lever when the door is opened.
The bolts are always extended 20 mm when the door is closed.
The Cylinder screw mount is intended for fixing the locking cylinder into the lock case using a cylinder
screw.
The Faceplate is screwed to the door.
The Latch pin is a four-edged pin which is inserted through the lock follower and ends in the door
handle. The latch pin is also split in lock mechanisms with split lock followers.
The Lock case contains the lock mechanism.
The locking cylinder is installed in the Cylinder recess and screwed in place using the cylinder screw.
The Backset is the distance from the keyhole centre to front edge of the faceplate.
The Centres (distance) is the distance between the centre of the keyhole and the centre of the lock
follower.
The Deadbolt throw indicates how far the bolt can be extended.
Product information