Problems, Causes, Solutions - Assa Abloy MSL mFlipLock basis 23421 Montage- Und Bedienungsanleitung

Problem
The door can be pushed
or pulled open by hand
although it should be
locked.
The bolt jumps back out
of the lock immediately
after opening the door.

Problems, causes, solutions

All manuals and user guides at all-guides.com
Problems, causes, solutions
Cause
The bolt is not extended when the door is closed.
The bolt is not extended when the door is closed.
Locking cylinder jammed.
Door handle cannot be pushed down far enough.
Rebate gap is set too wide.
Updated information, such as reports relating to additionally executed fire tests can be found at:
www.assaabloy.ch
Solution
Adjust the door and the position of the strike plate
so that the latch engages freely in the strike plate
and door frame and can position itself.
Check and replace the locking cylinder if necessary.
Check switchover operation using a key.
Check and, if necessary, correct the rebate gap.
EN
53