Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
4. Open glass cover, take out grease filter.
5. Hold exhaust hood up to wall in such a way that the clearance to the
cooker (at least 65 cm) is observed and the middle of exhaust hood and
the aid line align.
Alignment must be checked with spirit level.
6. Draw the two drill holes for mounting from the inside of the hood.
7. Remove the hood again.
8. Drill two holes in the wall with a diameter of ø 8 mm at the marked
spots.
9. Put two screw plugs in the drill holes.
10. Engage two screws into the wall.
11. Mount exhaust hood and tighten the two screws on the inside
of extraction hood.
12. Put both chimney facings together. Fix them by means of the
outer metal plate and bolts. Make sure that the inner chimney
facing is adjustable in upward direction.
13. Put the the chimney facing unit on the cover.
14. Hold the upper attachment bracket on the wall at the required height of the
chimney so that the centre of the bracket and vertical guide line for the cover
are flush. Mark two holes and drill them, insert the dowels (not supplied) and
install the attachment bracket on the wall.
15. Pull the upper chimney facing from the lower chimney facing upwards, and
fix it by means of bolts to the angle bracket and to under-side.
16. Guide the mains cable in the chimney cover, so that it is not visible, to the
socket and connect the cover.
12
All manuals and user guides at all-guides.com
Inner chimney
Inner chimney bracket
Guide line
Outer chimney
Preparation
Werbung
Kapitel
Inhaltsverzeichnis
