Display Elements And Connectors - axing SKF 42-00 Betriebsanleitung

Demodulation
The selection of the frequency and demodulation are both done in the tuner. The prepared data flow is passed
on to the modulators.
Output/modulators
8 or 16 output channels can be selected for the radio programmes. The frequencies of the output channels can
be configured between 87.5 and 108 MHz (50 kHz steps are permitted, a minimum distance of 300 kHz must
be maintained between the modulators).
1.3.

Display elements and connectors

1 8 or 16 LEDs for output modulators
Green (blinking)
2 Equipotential bonding connector
3 8 or 16 HF input LEDs
4 RF input 1...4
5 RF input 5...8
6 Test port (-30 dB
7 RF output
8 RJ-45 Ethernet port for configuration
2021-12-13 | Technical improvements, changes in design, printing and other errors reserved. | AXING-BA_SKF-42-82-00.pdf
Green modulation is ok
no data stream (no input signal, tuner not configured, no program
for output configured)
Red modulator in error state (e.g. input audio stream not supported)
Yellow MPEG data stream present
Off MPEG data stream not present
Page 5 of 24