English; Objective Of The Operating Manual; Safety; Correct Use - Mapal HTC Kurzanleitung

English

1

Objective of the operating manual

This manual describes the correct operation of the HTC clamping chuck. You will find de-
tailed information on how to clamp and unclamp a tool using the HTC clamping chuck. In
addition, the most important safety instructions on handling the HTC clamping chuck are
explained.
In section 4 in the following you will find a detailed description of the individual actions nec-
essary to successfully clamp and unclamp tools using the HTC clamping chuck.
2

Safety

2.1

Correct use

The MAPAL HTC clamping chuck is used only for clamping tools on machines for machin-
ing.
The HTC clamping chuck with adjustment of length has been specially designed for clamp-
ing rotating tools on machine tools for automatic tool changing.
NOTE
HTC clamping chucks may only ever be employed within the restrictions of its tech-
nical specifications (see section "3.2 Technical data"). Using the system with disre-
gard to even a minor specification will be deemed inappropriate use. The manufac-
turer assumes no liability for any injury or damage resulting from inappropriate use.
Additional modifications and extensions are not allowed without the written consent
of the manufacturer.
2.2

Target group

The HTC clamping chuck is only allowed to be used by trained, authorised and dependable
specialist personnel. The specialist personnel must be able to recognise and avoid hazards.
The health and safety regulations, safety stipulations and instructions from the machine
manufacturer are familiar to the specialist personnel and are to be followed and observed
during the operation of the HTC clamping chuck.
2.3

General warnings and safety instructions

Warning
Kurzanleitung / Short manual
MAPAL HTC Spannfutter / HTC Clamping Chuck
All manuals and user guides at all-guides.com
Failure to comply with the technical data in section 3.2
may result in injuries ranging from slight to serious.
 Ensure the technical data in section 3.2 are not exceeded.
19