Mapal HTC Kurzanleitung Seite 31

Caution
Figure 10: Adjusting tool
Warning
Caution
Kurzanleitung / Short manual
MAPAL HTC Spannfutter / HTC Clamping Chuck
All manuals and user guides at all-guides.com
Tool length adjustment with the tool clamped.
Performing an axial or radial tool length adjustment while the tool is
clamped will result in damage to the HTC clamping chuck.
 Do not perform a tool length adjustment while the tool is clamped.
Inadequate clamping to the stop and non-compliance with the
minimum revolutions
may cause the tool to be released at high projectile speeds, which can
cause serious injuries.
 During clamping, always screw in the clamping screw to the stop in
compliance with the minimum revolutions (see section "3.2 Tech-
nical data").
Using a power screwdriver to clamp the clamping screw
will increase the wear on the clamping screw.
 The clamping screw must only be clamped manually.
NOTE
Use only a hex wrench with T-key
and size 2.0 to tighten the tool length
setting screw.
3. Adjust the HTC clamping chuck to the tool
length by turning the radial tool length set-
ting screw with the aid of the hex-wrench
with T-key (see "Figure 10: Adjusting
tool").
31