Additional Functions - air&me ROHAN Bedienungsanleitung

ADDITIONAL FUNCTIONS

[ LIFT PUMP ] FUNCTION
H
Before activating the lift pump, remember to connect the drainage hose properly. To
activate or deactivate the lift pump, press and hold the [ Humidity rate ] button (
3 seconds.
[ MOVABLE FLAP ] FUNCTION
C
Press simultaneously the [ Timer ] (
activate or deactivate the [ Movable flap ] function.
CHILD SAFETY
J
By pressing and holding the [ Mode ] (
function that "lock" the control panel.
WI-FI
M
By pressing and holding the ON/OFF button (
between the appliance and your smartphone. Once this pairing is done, you can control the
dehumidifier from afar as soon as you have an internet connection.
LED DISPLAY
K
When the appliance works, the colour of the LED bar changes according to the ambient
humidity rate.
• The LED bar is green when the humidity rate is between 40 and 60%.
• The LED bar is blue when the humidity rate is lower than 40%.
• The LED bar is red when the humidity rate is higher than 60%.
Press simultaneously the [ Humidity rate ] (
the LED bar.
AUTOMATIC [ ANTIFREEZE ] FUNCTION
The appliance automatically enters in [ ANTIFREEZE ] function if the ambient temperature is
between 5°C and 15°C. Every now and then, the compressor stops but the fan continues
to work.
22
) and [ Inside drying of the appliance ] (
A
) button for 3 seconds, you activate the child safety
I
) for 3 seconds, you activate the Wi-Fi pairing
L
) and the [ Mode ] ( ) buttons to turn on or off
G I
EMPTYING THE TANK (SEE PAGE 3)
The appliance automatically stops working once the tank is full. The appliance rings 10 times and
the [ Full tank ] indicator (
) for
G
Turn the appliance off and pull the tank thanks to the side handles.
1
Unclip the handle and remove the water tank lid.
2
Empty the condensates.
3
Replace the lid and the tank. Then, press the ON/OFF button and choose the desired operating
4
) buttons to
B
mode.
The dehumidifier is equipped with a tank positioning sensor. As a matter of security, the product
turns off after few minutes if the tank is missing or not properly placed.
CONTINUOUS DRAINAGE (SEE PAGE 3)
Thanks to the continuous drainage hose, the appliance will work independently without having
to manually empty the tank.
Turn the appliance off, unscrew and remove the plastic plug from the hole for the continuous
1
drainage hose.
Connect the continuous drainage hose (60 cm and ø 13 mm) on the back of the dehumidifier.
2
To avoid leaks, make sure the hose is not bent and that it is placed on a downward slope so
that water can easily drain away. Do not modify or extend the drainage hose.
Turn the appliance on.
3
LIFT PUMP CONNECTION (SEE PAGE 3)
Thanks to the build-in lift pump, the appliance will work independently, without having to
manually empty the tank and will be able to discharge condensates upward.
Turn the appliance off and then remove the rubber plug from the hole for the lift pump hose.
1
Connect the lift pump hose (3 m and ø 5 mm) on the back of the dehumidifier. To avoid leaks,
2
make sure the hose is not bent. Do not modify or extend the lift pump hose. The lift pump hose
must not exceed 5 m.
Turn the appliance on. You can now activate the [ Lift pump ] function (
3
panel.
) lights.
E
) on the control
H
23