Eizo FlexScan T1501 Installationshandbuch Seite 9

Prior to use
No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.
1. Check the Power indicator.
Symptom
No picture
* For detail of the gain adjustment, please refer to the User's Manual on the CD-ROM.
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom
When failed to update the touch panel driver
If the installation is failed even after the following remedial action is taken, contact your local dealer.
1. Uninstall the touch panel driver.
2. Delete the folder to which the touch panel driver had been installed.
It is usually installed to "C:\Program Files\UPDD".
3. Install the touch panel driver according to the instructions included in the EIZO
LCD Utility Disk (CD-ROM).
Installation Setting/Adjustment
Status
Power indicator does not light
up.
Power indicator lights blue.
Power indicator lights orange.
Status
The input signal is not received.
The signal frequency is outside
the specification. Incorrect
signal frequency is shown in
red.
Troubleshooting
Possible cause and remedy
Check whether the power cord is correctly
connected.
Press .
Check the <Gain>* setting.
Switch the input signal with
Press a key on the keyboard or click the mouse.
Turn on the PC.
Possible cause and remedy
Check whether the PC is turned on.
Check whether the signal cable is properly
connected to the PC.
Switch the input signal with
Change the mode to an appropriate mode using
the graphics board's utility software. Refer to the
manual of the graphics board for details.
.
.
7