Emptying The Container; Adjusting The Nozzle; After Finishing Work - Stihl SGA 85 Gebrauchsanleitung

13 After Finishing Work

► Fill with plant protection product up to the
uppermost boundary line (3) at the most.
► Fit the cover (2) on the container.
► Manually rotate the cap (2) clockwise and
tighten it manually.
The container is locked.
12.3

Emptying the Container

► Switch off the sprayer and remove the battery.
► Unscrew lid.
► Remove lid with sieve.
► Empty container in a well-ventilated place so
that no residual quantity remains in the con‐
tainer.
12.4 Squeezing and locking the
spray gun trigger
Pressing the spray gun trigger
1
► Slide the retaining latch (1) to the
► Pull the trigger (2) and hold it there.
Plant protection product flows out of the noz‐
zle.
Locking the spray gun trigger
1
► Release the trigger (2).
Plant protection product no longer flows out ot
the nozzle. The sprayer is still switched on.
► Slide the retaining latch (1) to the
0458-600-9621-C
2
position.
2
position.
12.5 Adjusting Operating Pressure
and Flow Rate of Plant Protec‐
tion Product
1
To increase operating pressure and flow rate of
plant protection product
► Turn rotary control (1) in direction of "Max".
To reduce operating pressure and flow rate of
plant protection product
► Turn rotary control (1) in direction of "Min".
Operating pressure is indicated on the spray
gun's gauge (2).
12.6

Adjusting the Nozzle

The flow rates are specified in the technical data,
19.2.
A
Setting the full cone beam (A)
► Turn the nozzle counterclockwise as far as
stop.
Setting the spot jet (B)
► Turn the nozzle clockwise one full turn.
13 After Finishing Work
13.1 After Finishing Work
► Switch off the sprayer and remove the battery.
► Pull the trigger.
Pressure is relieved.
► Drain the tank in a well ventilated location.
► Rinse the tank with clean water.
► Fill the tank with clean water.
► Fit the battery and switch on the sprayer.
English
2
B
33