Steinbach Poolrunner S63 Originalbetriebsanleitung Seite 40

Disconnecting the control unit
Handling the power plug with wet hands can lead to an electric
shock.
- Never touch the power plug with wet hands.
1. Disconnect the power plug from the grounded socket.
2. Undo the screw fitting of the plug on
the control unit
floating cable
The control unit is disconnected.
Lifting the device out of the pool
Risk of electric shock if the control unit drops into the filled pool
while it is connected to the power supply.
- Pull the power plug out of the socket before lifting the device out
of the pool.
1. Slowly pull the device by the floating cable
can reach the handle
2. Slowly lift the device out of the water by the handle
surface for 10 to 15 seconds so that most of the water can flow back into the pool.
3. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued fault-free operation.
40
Risk of electric shock!
and pull of the
5
.
1
Risk of electric shock!
.
8
WARNING!
12
WARNING!
towards the water surface until you
1
1
and hold it above the water
8
5