Operation - Fujitsu UTY-RSNYM Bedienungsanleitung

OPERATION

Instructions relating to heating are applicable only to "HEAT & COOL MODEL " (Reverse Cycle).
Preset values are displayed when the "
while stopping.start/stop operation
To start/stop operation
To set the operation mode
● Operation mode setting
● Room temperature setting
Rise
Lower
● Fan speed setting
NOTES
(1) Display panel lights up.
(2) When is displayed, there are functions for which settings cannot be made.
When a button is pushed to change a restricted setting,
(3) During Automatic Defrosting operation and Oil Recovery operation,
(4) When connecting with other controllers, the indoor unit might be controlled by the other controllers.
(5) The wired remote controller or the wireless remote controller can also be used with this unit.
(6) Simultaneous use of multiple units.
Operation cannot be done in the following different operating modes.
If the indoor unit is instructed to do an operating mode that it cannot perform,
controller display and the unit will go into the standby mode.
• Heating mode and cooling mode (or dry mode).
• Heating mode and fan mode.
En-3
" button, the "
Press the " " button.
START/STOP LED
Air conditioner ON: Lit brightly
Air conditioner OFF: Not lit
Blinking of START/STOP LED means occurrence of an error. Please refer to "ERROR
CODE DISPLAY" in the manual.
Press the " " button to set the operation mode.
If DRY is selected, the fan speed will be set to AUTO.
AUTO COOL
Press the " " button or "
Temperature setting range
AUTO ............................................... 18 to 30°C
COOL/DRY ....................................... 18 to 30°C
HEAT ................................................ 16 to 30°C
Press the " " button to select the fan speed while in operation.
Fan speed display
(AUTO) (HIGH)
(Select the fan speed
automatically.)
" button or " " button, the "
DRY FAN HEAT
" button to set the room temperature.
(MED) (LOW) (QUIET)
will fl ash.
will be displayed on the remote controller.
will be shown on the remote
" button is pressed