McCulloch B40 B Elite Bedienungsanweisung Seite 13

CAUTION:
extension is removed.
1. Attach the blade guard/cutting attachment guard (A)
onto the shaft and tighten with the bolt (L).
L
2. Install the drive disc (B) on the output shaft.
3. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the blade (E), support flange (F) and the support
cup (G) on the output shaft.
6. Install the nut (H). Hold the shaft of the wrench near
the blade guard as much as possible. To tighten the
nut, you must turn the wrench in the opposite
direction of rotation. Tighten the nut to a torque of
35-50 Nm (3.5-5 kpm).
E
A
C
Note:
Left hand thread.
1681 - 001 - 28.06.2021
Make sure that the guard
C
A
A
H
G
F
B
To attach the trimmer guard and the trimmer
head
Note:
Make sure to use the correct trimmer guard for
the correct trimmer head.
1. Attach the correct trimmer guard/combination guard
(A) for the trimmer head.
B
2. Install the trimmer guard/combination guard around
the shaft and tighten it with the bolt (B). Use the
locking pin or hex key (C).
3. Put the locking pin or hex key (C) in the groove on
the screw head and tighten.
4. Attach the drive disc (D) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the hole in the gear housing.
6. Install the locking pin or hex key (C) in the hole to
lock the shaft.
7. Assemble the trimmer head/plastic blades (E). Turn
the trimmer head/plastic blades counterclockwise.
8. To disassemble, follow the instructions in the
opposite sequence.
A
C
E
B
A
D
13