Multiplex ROXXY PROcontrol Serie Bedienungsanleitung Seite 11

Full throttle Connect battery to the controller
1
TJ
TJ
2
TJ
TJ
3
TJ
TJ
4
TJ
TJ
5
TJ
TJ
6
TJ
TJ
7
TJ
TJ
8
TJ
TJ
9
TJ
TJ
TJ
ROXXY PROcontrol Series – Operating Instructions,
# 1-02103, 1-02104, 1-02105, 1-02106, 1-02107, 1-02108, 1-02109
2 seconds
Programming mode
Brake
Brake off
Soft brake
Mid brake
Hard brake
Battery type
Nicd/NiMh
LiPo
LiFe
Undervoltage threshold
2.8 V per cell
3.0 V per cell
3.2 V per cell
Undervoltage protection deactivated
Reset to factory setting
Timing
Auto
2°
8°
15°
22°
30°
SBEC voltage
5 V
6 V
7.4 V / 5 V for PROcontrol 45
8.4 V / 5 V
Governor mode
Deactivate speed control
Soft start 1, 8-sec. delay
Soft start 2, 15-sec. delay
Governor mode 1, low KV
Governor mode 2, high KV
Reversing the direction of rotation
Normal
Reversed
Start-up behavior
10%
15%
20%
25%
30%
35%
40%
45%
50%
Cut-off mode
Throttling
Hard cut-off
TJ
TJ
If the controller is connected at full throttle, a
signal sequence of two fast beeps sounds four
times in succession after approximately two
seconds. You are now in programming mode.
As long as the throttle joystick is not moved to
the idle position, the programming process con-
tinues point by point. To change the values for a
programming point, move the throttle joystick to
the neutral position.
When the correct value has been reached, con-
firm it with full throttle. This saves the value and
programming now continues with the next point.
If you want to exit programming mode, simply
disconnect the battery.
Adjustments for
motors with a low
starting current
Medium starting
current
High starting
current
11
Fast signal
Signal
Long signal
Pause
Melody
Throttle joystick, full throttle
Throttle joystick, idle