Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Recycler 20954 Bedienungsanleitung

1. Handle knob
5. Loosely install the handle knobs onto the
carriage bolts.
6. Refer to steps 3 through 5 of
Handle Height (page
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle and
pull the recoil-starter rope through the rope guide on
the handle (Figure 7).
1. Recoil-starter rope
All manuals and user guides at all-guides.com
Figure 6
2. Carriage bolt
Adjusting the
9).
Figure 7
2. Rope guide
3

Filling the Engine with Oil

No Parts Required
g189871
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
g003251
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5
0.44 L (15 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 8
3. Add
(Figure
8).
g187518
8).