Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro 53cm Super Recycler 20792 Bedienungsanleitung

4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height (page
5. Torque the handle bolts to 14 to 17 N∙m (120
to 160 in-lb).
6. Adjust the cutting height. Refer to
Cutting Height (page
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the
recoil-starter rope in the rope guide.
Hold the blade-control bar to the upper handle and
pull the recoil-starter rope through the rope guide on
the handle (Figure 5).
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine Oil Specifications
11).
Adjusting the
11).
Figure 5
2. Rope guide
Engine Oil Specifications (cont'd.)
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Dipstick
2. Add
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
g003251
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
7
0.44 L (15 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 6
3. Full
(Figure
7 until the oil on the dipstick is at
Changing the
21).
If the oil level in the engine is too
6).
g187518
6).