Technical Data; Fault Finding And Correction - HEYLO ACE Bedienungsanleitung

(6) Technical data

Model
Current consumption (A)
Air flow rate m³/h je Stufe
rpm
Compression (Pa)
Volume (dB(A))
Height / Width / Depth (mm)
Weight (kg)
Stackable
Cable length (m)
CAUTION: Within the scope of further development, technical data may be changed without prior
announcement. Some values are approximate values.

(7) Fault finding and correction

WARNING: Maintenance work shall have to be carried out with the unit switched off, i.e. with mains
plug removed.
PROBLEM
Motor is not operating
The motor is running,
but the impeller turns
irregularly or makes
contact
Unit vibrates excessively Collection of dirt on the
B = User | AST = Authorised service technician
All manuals and user guides at all-guides.com
1,230 low – 1,445 high
CAUSE
No power to unit.
The unit has not been
switched on.
Impeller is blocked.
Air inlet or outlet is blocked.
Switch has broken off.
Loose wiring.
A heavy impact has bent the
motor suspension so that the
impeller jams.
A heavy impact has caused
the motor to slip out of the
suspension so that the
impeller jams.
wheel.
Unbalance of the impeller.
Impeller is bent.
Motor shaft is bent.
11
ACE
1.0
2,930 / 3,880
250
67 / 71
610 / 510 / 480
16.3
Yes
7.6
Versi SOLUTION
on
B Connect the unit; check the fuse.
B Switch the unit on.
B Remove the reason for the blockage.
B Switch the unit off and let it cool down;
then remove blockage.
AST Order replacement switch from the dealer
or HEYLO.
AST Check wiring and tighten, if required.
AST Remove the motor from the housing,
replace or repair the bent motor
suspension.
AST
Remove the motor from the housing, then
place the motor in the suspension
correctly.
B Clean impeller.
AST Balance or replace the impeller.
AST Replace impeller.
AST Replace motor.
EN