General Aspects / Safety Guidelines; Application; Setting Up The Ventilator - HEYLO ACE Bedienungsanleitung

All manuals and user guides at all-guides.com

(1) General aspects / Safety guidelines

CAUTION: Read carefully before starting up !
Please observe the notes in the operating instructions carefully. In case of non-observation, the
warranty claims will become void. The manufacturer shall not be liable for any damage and/or
consequential damage resulting.
Keep away from children: Do not allow children to play with or in the vicinity of the device.
Electric connection: The ACE Turbo Ventilator is designed for operation with 230V/50Hz. Use
shock-proof plugs only. The sockets used have to be earthed !
Protect the power cable against damage: Never use the unit with damaged power cable. If the
power cable has been damaged, it has to be replaced by a cable of the same type and dimension.
Extension cable: Use approved extension cables only !
Handle with care: Do not drop or throw the unit as this may cause damage to the unit or wiring.
Operate on solid surface: Always set up the unit on a solid and plane surface.
Secure during transport: When transporting devices in vehicles, secure against slipping.
Keep dry: The unit must not be operated in puddles or in standing water. Do not store or operate
outdoors. If the electric wires or parts of the unit get wet, the unit has to be thoroughly dried before re-
using.
Keep the air openings free: Do not cover or block the air inlets and outlets.
Do not use any speed controller: In order to reduce the risk of motor failure, Turbo dryers should not
be used with electronic speed controllers.
Repair of the device: Please have the repairing work carried out by service partners of HEYLO
Company only. Information about approved service technicians can be obtained by phone, fax or e-
mail.

(2) Application

ACE Turbo Ventilator are constructed so that they blow air across wet surfaces in order to quickly dry
them. The high-volume air flow generated by the turbo dryer increases evaporation, helps avoid mould
growth and thus reduces the risk of additional damages due to humidity. Flowing air improves the
evaporation as the boundary layer of the saturated air is blown way which is produced over the wet
surfaces. The turbo dryers tear off this humid air and replace it by drier air.

(3) Setting up the ventilator

In order to dry a building, at least one turbo dryer should be set up in each room. Set up as many units
as required for maximum air flow across all wet floor spaces.
Make sure that all wet surfaces are exposed to the air flow. Open the room doors in order to improve
air circulation.
EN
8