Technical Data; Troubleshooting - HEYLO TD 300 Bedienungsanleitung

8. Technical Data

Model
Air flow rate max.
Connection
Fuse
Height x Width x Depth
Weight
Engine output
Noise level at 1 m distance
IP-class
Attention: Technical data can be changed during the course of further development without prior
announcement. Some values are approx. – values.

9. Troubleshooting

WARNING: All maintenance work listed below must be carried out without current, i.e. with the plug
pulled out.
PROBLEM
Motor does not run
Motor runs but wheel
turns irregularly or
hits the sides
Device vibrates
excessively
Exec.: B - User
Contact your local dealer or HEYLO customer services department for spare parts and service.
CAUSE
No power supply to the
device
Switch not turned on
Fan wheel blocked
Air inlet or outlet blocked
Switch interrupted
Wiring loose
A heavy impact has bent
the engine suspension so
that the wheel is stuck.
A heavy impact has let the
engine slide out of the
suspension so that the
wheel is stuck.
Collection of dirt on the
wheel
Unbalance of the
wheel
Fan wheel bent
Motor shaft bent
AST - authorised service engineer
TD 300
445 m³/h
230V / 50Hz
16 A
30 x 25 x 28 cm
3,2 kg
85 W
58 dB(A)
IP 22
Exec. SOLUTION
B Connect device, check fuse.
B Turn on switch
B Remove reason for blockage
B Switch off machine and let it cool off;
then remove blockage.
AST Order a replacement switch from the
dealer or HEYLO.
AST Check wiring and tighten as
requirement.
AST Dismantle engine from the housing,
then replace or repair the bent engine
suspension.
AST Dismantle the engine from the housing
and then place it correctly into the
suspension.
B Clean fan wheel
fan AST Balance out or replace fan wheel
AST Change fan wheel
AST Change motor
11
per
EN