cecotec POWER ESPRESSO 20 BARISTA CREAM Bedienungsanleitung Seite 22

ENGLISH
When the grinder function cannot be used normally, the indicator light on the left side will
beep three times.
When the bean grinder function is used for 3 minutes in a row, the system will automatically
stop the function. After 6 minutes, the system will be able to operate again. When this happens,
press the grinder button and the device will beep three times and the light on the left will flash.
Grinding time adjustment
This allows the user to use the grind function by the touch of a button. Long press the grind
button and it will start operating. The system will record it and the next time the grind button
is pressed, it will operate following this.
The system only records times longer than 5 seconds.
Warnings:
Single or double espressos can be brewed only after the device has preheated.
The machine will beep and its indicator lights will turn on when there is not enough water in
the water tank. After refilling it, it will return to normal conditions.
After running the steam function, wait until it enters standby mode before brewing coffee or
dispensing hot water. These functions cannot be used while the machine cools down.
Empty the cup-holder tray when the full tray indicator raises.
Tube cleaning reminder
The system includes a cleaning-reminder function and a cleaning program, which requires
the user's cooperation to complete during the cleaning process. The entire cleaning process is
expected to take about 10 minutes.
When starting the cleaning program, make sure the water tank is filled with at least 1 liter of
water.
Empty the cup-holder tray and put it back into place.
Turn the device on and activate standby mode.
Place two cups into the funnel and screw it to the funnel holder.
The cleaning function can be exited at any time by pressing the power button.
When the cleaning program starts, the indicator light and the left side light will flash, and will
flash during the whole process.
If the descaling system does not start within 1 minute, the appliance will exit the descaling
cycle and return to standby.
Descaling
Descaling instructions
We recommend descaling every 4-6 months.
Descaling tablets, liquid descaling agent, white vinegar and warm water can be used for this
purpose.
The descaling cycle takes about 10 minutes to complete.
42 POWER ESPRESSO 20 BARISTA CREAM
Descaling preparation
Introduce in the water tank with descaling tablets, liquid descaling agent, white vinegar or
warm water.
Descaling tablets: Fill 1 liter of water into the water tank. Add descaling tablets and wait for the
descaling tablets to dissolve.
Liquid descaling agent: Add half a cup of liquid descaling agent to the water tank, and then pour
1 cup of warm water to allow the solution to mix thoroughly.
White vinegar/warm water: Add 1.5 spoons of white vinegar to the water tank and then a cup
of warm water to allow the solution to mix thoroughly.
Put the water tank into place.
Fig. 6
Place a 1-liter container under the brewing head and another one under the steam tube.
Fig. 7
When the system detects that the machine reaches 15L, the cleaning reminder function will be
activated and automatically enter the cleaning program.
In standby mode, long press On / off button and Grind will start the cleaning process;
When the left side is flashing quickly:
Start the descaling cycle by turning the dial to froth position. Its indicator light will light up.
Water will start to pump and hot water will come out from the brewing head and steam pipe.
After two minutes, the sound will change.
The froth indicator light will turn off and the indicator light with the dot will start to flash,
indicating this step has been completed.
Turn the dial to this position. Its indicator lights along with the froth's and the water drops' will
light up.
Cleaning up
The following instructions should be done before 5 minutes.
Clean the steam pipe and the brewing head to remove the descaling solution.
Clean the water tank with water.
Turn the dial to the froth position. Its indicator light will light up.
Water will start to pump and hot water will come out from the brewing head and steam pipe.
After two minutes, the sound will change. Descaling will be completed when water stops
coming out.
When the descaling cycle is complete
The indicator light will turn off and the indicator light with the dot will start flashing, indicating
that the machine has completed this function.
Turn the dial to its starting position.
The froth indicator, along with the one with the dot and the water drops will all light up.
To indicate the completion of the descaling process, the device will beep and the power
indicator light will flash.
ENGLISH
POWER ESPRESSO 20 BARISTA CREAM 43