Technical Data - Wolf Garten GT-S 800 Originalbetriebsanleitung

GT-S 800/1000
Before using your power tool read carefully the manual instructions
1. P
RESENTATION
Dear Customer,
Thank you for choosing one of our
products. We are sure you will be
satisfied by it and that it will fully meet
your requirements. This manual has
been written to allow you to become
familiar with your machine and use it
safely and efficiently; please do not
forget that it is an integral part of the
machine, keep it to hand so that you
can consult it at any time and, if you de-
cide to sell or lend it to other people,
make sure it stays with the machine.
Your new machine has been designed
and built in compliance with current
legislation and is safe and reliable if
used according to the contents of this
manual (foreseen use); any other use
or failure to observe the safety
instructions concerning use,
maintenance and repair is considered
as "improper use" and invalidates the
warranty, releases the Manufacturer
from all liability, and transfers to the
user all costs deriving from damage or
injury to him/herself or to other people.
If you find slight differences between
the descriptions in the manual and the
machine in your possession, please
bear in mind that, as the product is
continually improved, the information
contained in this manual is subject to
change without notice or the need to
update the manual as long as the
essential safety and operating
characteristics remain unchanged.
Please contact your dealer if you have
any doubts. We trust you will make the
most of this machine!
24
2. T
ECHNICAL DATA
Model
Voltage
Power frequency
Electrical engine no load speed rpm
Cutting width
Weigth
Model GT-S 1000
Voltage
Power frequency
Electrical engine no
load speed
Cutting width
Weigth
3. S
YMBOLS
The following symbols are used in this
manual or are indicated on the
machine. Before read it they must be
known.
Denotes risk of personal injury,
loss of life or damage to the tool
in case of non observance of the
instruction in this manual.
Read the instructions manual
before using this machine.
Use always: safety helmet,
noise-damping earplugs,
protective gagglers or visor.
Danger of flying objects!
No-one must remain
within a radius of 15
metres while the
machine is working.
GT-S 800
V 230
Hz 50
7000
cm 38
Kg 6,0
V 230 230
Hz 50 50
rpm 7000 8700
cm 38 23
Kg 6,2 6,2