Precautions And Safety Measures; Before And During Use; After Use - HT Instruments EASYTEST-COMBI5-SUPERCOMBIS-Serie Kurzanleitung

1. PRECAUTIONS AND SAFETY MEASURES

The instrument has been designed in compliance with guidelines IEC/EN61557, BS7671 17th and 18th
editions and IEC/EN61010-1, relevant to electronic measuring instruments. Before and after carrying out the
measurements, carefully observe the following instructions

Do not measure voltage in wet or dusty places

Do not measure in presence of gas, explosive materials or combustibles

Do not touch the circuit under test if no measurement is being taken

Do not touch exposed metal parts, unused terminals, circuits and so on

Do not use the meter if it seems to be malfunctioning (i.e. if you notice deformations,
breaks, leakage of substances, absence of messages on the display and so on)

The meter has been designed for use in places with pollution class 2

Do not take measurements on circuits exceeding the specified voltage limits

Before connecting cables, crocodiles and clamps to the circuit under test, make sure that
the right function has been selected

The meter is designed for measurements on installations of excess voltage category CAT
IV 300V to earth and 415VAC maximum voltage between inputs. Do not use on systems
exceeding the limit values specified in technical specifications of user manual

Only the accessories provided with the instrument guarantee compliance with safety
standards. They must be in good conditions and must be replaced, if necessary, with
identical models
The herewith symbols are used on meter:
CAUTION: keep to what described by the manual. An incorrect use could damage the instrument
or its components
High voltage: risk of electric shock
Double insulation
DC Voltage or Current
AC Voltage or Current
Ground reference
The symbol indicates that the instrument must not be connected to systems with phase-to-phase
rated delta voltage higher than 415V.
CAUTION: this symbol indicates that equipment and its accessories shall be subject to a
separate collection and correct disposal
1.1.

BEFORE AND DURING USE

Before and during measurements please take care of herewith points:

Do not touch any unused terminal when the meter is connected to the circuit under test

We recommend following the normal safety rules devised to protect the user against dangerous currents
and the instrument against incorrect use

The symbol " " indicates the charge level. When there are five bars, it means that batteries are fully
charged; a decrease in the number of bars down to "
this case, interrupt tests and replace the batteries according to the indications given in the user manual
1.2.

AFTER USE


After use, turn off the instrument by pressing ON/OFF key for a few seconds

If you expect not to use the instrument for a long time please keep to the storage instructions described
in the user manual
Please read the instruction manual of the instrument which is included on CD-ROM
:
CAUTION
" indicates that the batteries are almost low. In
CAUTION
support, before use
EN - 2
EASYTEST-COMBI519-COMBI521
Quick reference guide