Citysports CS-WP2 Produktanleitung Seite 11

If you turn right, use a hexagonal wrench and turn the right screw clockwisefor 1/4 turns.
ＥＮ
If the running belt is still not in the middle, repeat the above action until it is adjusted to
the middle.
3. After adjusting the running belt to the middle, adjust the speed to the high speed, and
observe the steps.
deviation of the running belt and the running smoothness. If there are devi
ations, repeat the adjustment
4. If the above steps do not work, you need to tighten the running belt again.
Warning! Do not over tighten the drum! This will lead to permanent bearing damage!
2. Lubricating oil for walking machine
The walking machine has been pre-lubricated before leaving the factory. But because the
friction between the running belt and the running board has a great influence on the service life and
performance of the product, lubricating oil should be added according to the machine prompt.
Whenever the cumulative mileage of the walking machine reaches 100 KM, the display screen will
display a red refueling display.
Note: Please use treadmill lubricant or contact our company directly.
Lubrication steps
Cut the seal of the inner mouth of the oil bottle and cut a small opening of the cap of the oil
bottle (it can be extruded smoothly).
Turn up the plug cover of the filling hole.
Set the machine to 1 KM speed, and extrude the appropriate amount of oil at the orifice of the
oil bottle, about 20 ml each time.
After adding silicone oil, the machine runs for about 3 minutes. When the silicone oil reaches
the running belt evenly, press the remote control key to stop the machine, and then press the
remote control + key for 20 seconds to clear the refueling prompt icon.
Lubricating hole plug
Fuel up.
silicone oil
Note: attention should be paid to safety during refueling operations.
Lubrication sign
- 9 -