Citysports CS-WP2 Produktanleitung Seite 10

running belt. This will reduce the accumulation of impurities in the running belt. Keep
your sneakers clean. Avoid bringing foreign bodies under your running belt and wearing
your running board and belt. The surface of the running belt should be scrubbed with
a soapy wet cloth.
Please be careful not to splash water on the electrical components and under the running belt.
Check and lock all parts of the treadmill regularly, replace defective parts and/or leave the
equipment idle for repair.
1. Adjusting the Running Belt
If you are using a walking machine, you can adjust the belt tightness to improve the slippage or
non-fluidity of the running belt.
Adjusting running has two functions: tightening adjustment and belt center position adjustment.
Running belt has been adjusted when it is out of the factory, but after use, the running belt will be
stretched, which will deviate from the center position and cause the running belt to rub the foot sidebars
and rear cover damage. It is normal for the running belt to be stretched during use.
Adjusting Running Belt Method
Step 1: Insert the 5 mm hexagonal wrench into the adjusting screw on the left side of the belt, and
turn the wrench 1/4 times clockwise to adjust the rear drum to tighten the belt.
Step 2: Insert the 5 mm hexagonal wrench into the adjusting screw on the right side of the belt, and
turn the wrench 1/4 times clockwise to adjust the rear drum to tighten the belt.
Step 3: Repeat steps 1 and 2 until the running belt does not slip.
Note: The belt should not be adjusted too tightly. This will break the running belt, increase the
pressure of the front/back drum, bring harm to the drum bearings, produce abnormal sound or other
problems.
If you want to reduce the tension of the running belt, please rotate the wrench counterclockwise.
Note that the left and right sides should rotate the same distance.
Running belt centered
When you use a walking machine, the pressure on the running belt is unbalanced due to the different
force exerted by the two feet during running, which results in the belt deviating from the center. This
deviation is normal, and when no one runs on a running belt, it returns to the center. If you can't get back
to the center, you need to bring the running belt back to the center.
1. Running the treadmill without load and adjusting its speed to 6km/H.
2. Observe the distance from the running belt to the left and right sidebars.
If left, use a hexagonal wrench and turn the left screw clockwise for 1/4 turns.
Loosen
Fasten
Loosen
- 8 -
Fasten
ＥＮ