Device Operation And Control - HEYLO BT 60 Betriebsanleitung

Dehumidifier BT 60
Fig. 33: Pushing in handle
c) Place the second device on the first one. En-
sure that the handle of the device at the bottom
fits into the recess in the device at the top.
Fig. 34: Stacking devices for operation or storage
Connecting device to power supply
a) Place the plug of the device in a power socket
that is earthed or protected by an integrated
earth leakage circuit breaker (see Technical de-
tails [ 39]).
b) If necessary, check and record the operating
hours counter before switching the device on.
 The device is now installed and ready for infor-
mation.
Installing condensate pump (optional)
The optional condensate pump replaces the water
tank in the device.
32 / 42
Procedure
✓ Shut down the device and disconnect it from the
power mains.
a) Remove the water tank.
b) Install the condensate pump, following the in-
structions shipped with the pump.
16 Device operation and
control
CAUTION
Risk of infection
The condensate may be contaminated with patho-
gens.
a) Never drink the condensate.
b) Regularly empty the water tank to avoid leaving
condensate in the device.
Before switching on:
a) Make sure that the device is not standing on a
wet surface and is in an upright and stable posi-
tion.
b) Make sure the power cord is not damaged.
c) Make sure that the device is connected to a
power socket with the correct voltage and pro-
tection (seeTechnical details
d) Make sure that the condensate can drain off
safely. Check whether the water tank is correct-
ly installed.
e) If necessary, read the operating hours and kWh
counters and document the values.
f) Make sure that all instructions in the Operating
conditions [ 26] are adhered to.
Switching device on
1
Fig. 35: Switching on at control panel
1 ON/OFF button
a) Press the ON/OFF button at the control panel.
 The fan and the compressor start.
[ 39]).
EN