Transport And Installation; Unpacking - HEYLO BT 60 Betriebsanleitung

Dehumidifier BT 60
Button Description
Dehumidification on – the green LED indi-
cates that dehumidification is in operation.
Water tank full – the dehumidifier has been
switched off because the water tank is full.
The "Error" indicator is lit, if there is an error
or alarm signal (see also Malfunctions dur-
ing operation [
Excessive pressure/temperature in circuit –
the dehumidifier has been switched of au-
tomatically to protect the compressor, be-
cause the temperature reached 60 °C.
After 30 minutes, the device restarts auto-
matically. During the waiting time of 30
minutes, the error indicator is lit in red.
Indicators working without power supply
The device is equipped with a battery that powers
the display when the dehumidifier is not connected
to the power mains.
Step Button Description
SERVICE xxxxh – indicates the
Press
and hold hours until the next authorised
service is due. The displayed val-
ue flashes for 5 seconds, and is
then stored to activate the function
(unless it is already active). When
the set service interval has
elapsed, message "SERVICE" is
displayed.
Hold Indicates total energy consump-
and tion of device in kWh.
press
1x
Hold Indicates total operating hours of
and device.
press
1x
Tab. 8: Reading and setting service hours counter
15 Transport and
installation
The device has been assembled, configured and
tested at the factory. In order to avert the risk of
serious or fatal injury and damage to the device
during transport and installation, observe the follow-
ing:
– The device must be transported and installed by
a suitably qualified and authorised person.
– Transport routes must be sufficiently large for
safe passage.
30 / 42
34]).
DANGER
Danger to life from electric shock
Touching live parts can be fatal.
a) Before transporting the device to a different
location, switch it off at the ON/OFF button and
disconnect it from the power socket.
b) Never pull the device by the power cord; al-
ways move it by the handle provided.
CAUTION
Risk of injury due to the device toppling
over
There is a serious risk of injury, if the device topples
over or falls during transport.
a) Wear safety footwear and protective gloves.
b) Hold the device by the handle and move it with
the help of the wheels.
NOTICE
Instructions for start-up
If the device has been transported in a horizontal
position, place it upright and leave it in this position
for minimum one hour.

Unpacking

a) Open the packaging at the top.
b) Position the carton so that the wheels are on
the ground.
Fig. 29: Unpacking
c) Pull the device from the carton.
d) Loosen the two star grip screws, pull the handle
to the desired position and then tighten the star
grip screws.
EN