Spectra
Loading label roll in rewind mode
In rewind mode the labels are wound up internally after printing for later use.
Open the printer cover.
Open printhead (A) by turning the red pressure lever (B) anticlockwise.
Spectra 216:
Pull centring plate (K) outwardly.
Remove the outside label mounting plate (C).
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate.
Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
Place the labels around the front sheet (G) and lead them below the mechanics to the rear.
Clamp the label material, with the handle (H) designated for it, at the rewinding roll (I).
Spectra 216:
Lift centring plate (K) again upwards.
In order to move the printhead (A) down, turn the red pressure lever (B) in clockwise direction until it locks.
Adjust the adjusting rings (J) of the label guiding to the width of material.
Close the printer cover.
86
All manuals and user guides at all-guides.com
English