Supra TERTIO 76 VL1 Installations- Und Bedienungshandbuch Seite 17

ASSEMBLING THE HEARTH + FEET + FAN
STEP 1: Attach the feet («Hearth + Feet»)
STEP 2: Removing the floor protection sheet («Hearth + Fan»)
STEP 3: Attach the ventilation box onto the frame for the feet
Tertio 67 and 76
1. Attach the fan kit to the frame for the feet (C) using the
4 bolts and 4 nuts, placing the head of the bolt inside
the ventilation box.
2. Tilt the fan-foot assembly on its back, being careful not
to damage it.
Tertio 55
1 Take the front panel off the fan unit
by loosening screws (E).
2 Remove the fan motor by loosening
screws (F).
3 Attach the ventilation box to to
the frame for the feet (C) using
the 4 bolts and 4 nuts. Place the
head of the bolt under the
ventilation box.
Refit the fan motor and front panel
using bolts (E) and (F).
Tilt the hearth onto its back.
STEP 4: Attaching the floor protection sheet.
Front
Large fold facing
upward
2 screws
Nº10
1. Turn the floor protection sheet so that the large fold is
at the front of the hearth facing upwards and the small
fold at the rear of the hearth.
2. Attach the protection sheet to the ventilation box using
2 screws Nº10 (cross-head) Two spacers make it
possible to keep a gap between the protection sheet
and ventilation box.
STEP 5: Fitting the hearth onto the feet + fan assembly.
Tertio 67 and 76
1 Take the side
panels off the
ventilation box by
removing screws
(G).
2 Fit the hearth onto the fan using the
4 screws (B).
3 Stand the assembly back up on its
feet and check that it is level, if
necessary, use the levelling jacks
(adjustable screws) on the feet.
4 Attach the ventilation box to the
back of the hearth using the 2 screws
(D).
5 Put the side panels back
onto the ventilation box.
Back
Spacers
Small fold facing
downward