Inhaltsverzeichnis
Werbung
•
Bewahren Sie Chemikalien, kleine Teile und Elektrogeräte stets außerhalb der Reichweite von Kindern
auf.
•
Niemals Teile des Modells in den Mund nehmen, da dies zu schweren Verletzungen oder sogar zum
Tod führen kann.
As the owner of this product, you are solely responsible for operating in a manner that does not endanger
yourself and others or result in damage to the product or the property of others.
•
Never attempt to swim after a stalled RC boat.
•
Never operate your RC boat while standing in the water.
•
Never operate your RC boat in the presence of swimmers.
•
RC boat running hardware is very sharp. Be very careful when working on and around the metal parts.
•
While the motor is running pay close attention to the propeller. Do not come in contact with the propeller
at any time the engine is running, or serious injury will result.
•
Always keep a safe distance in all directions around your model to avoid collisions or injury. This model
is controlled by a radio signal subject to interference from many sources outside your control.
Interference can cause momentary loss of control.
•
Always avoid water exposure to all equipment not specifically designed and protected for this purpose.
Moisture causes damage to unprotected electronics
•
Always keep all chemicals, small parts and anything electrical out of the reach of children.
•
Never place any portion of the model in your mouth as it could cause serious injury or even death.
•
Always keep all chemicals, small parts and anything electrical out of the reach of children.
AKKU INSTALLATION / BOAT BATTERY INSTALLATION
1. Drehen Sie die Luke auf der Rumpfabdeckung im Uhrzeigersinn, um die Luke zu öffnen.
2. Öffnen Sie die Rumpfabdeckung.
3. Legen Sie das mitgelieferte Schlaufenband um den Akku.
4. Befestigen Sie den Akku indem Sie die Flauschseite des Klettbandes auf die Hakenseite kleben.
5. Sichern Sie den Akku wie abgebildet mit dem Klettverschluss im Rumpf.
1. Roat the hatch on the hull cover in clockwise to unlock the hatch.
2. Open the hull cover.
3. Adhere loop tape (included) to the battery.
4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop strap as shown.
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL SPEEDBOAT MONO
Werbung
Inhaltsverzeichnis
