Sauna Heater Controls; Timer; Thermostat; Electric Heating Toggle - Helo Hanko STJ Produkthandbuch

Product Manual Hanko STJ

2.3 Sauna heater controls

2.3.1 Timer

The sauna heater is controlled by operating a 12-hour timer with three operating zones. The timer is set by twisting the
knob clockwise until the desired operating zone is reached. When operating, the timer gradually travels counter-clockwise
towards the zero position.
1. 0 position. The sauna heater is not on.
2. Operating zone 1–3 hours. Set on this zone, the sauna heater heats up at
full power while the sauna thermostat controls the temperature.
3. Preset zone 1–9 hours. Set on this zone, the sauna heater can be preset
to turn on after a certain period of time. The heating elements will not heat
up when the timer is within this zone.
Before turning the sauna heater on, make sure the sauna room is suitable for
taking a sauna bath.
The timer operates better if it is first turned further than the desired time and then
turned back to the desired time. If the switch has not travelled back to 0 position
after finishing bathing, turn it to 0 manually.

2.3.2 Thermostat

The thermostat knob is next to the timer knob. The further right (clockwise) the timer
is switched, the higher the temperature will rise in the sauna room. The best way to
find the ideal temperature is to first turn the thermostat fully on the right and let the
temperature rise to the desired temperature.
Subsequently, turn the thermostat knob slowly counter-clockwise until you hear a
gentle clicking sound. If you want to readjust the temperature, turn the thermostat
gradually until the temperature is ideal.
The thermostat will not operate correctly if the stones are piled too densely or they
are too small. Please refer to section "Sauna heater stones" on page 5.
The thermostat has an integrated temperature limiter with a reset switchnext to the
thermostat knob.

2.4 Electric heating toggle

Electric heating toggle applies to homes with an electric heating system.
The sauna heater thermostat also controls the heating toggle. In other words, home heating turns on once the sauna ther-
mostat cuts power off the sauna heater.

2.5 If the sauna heater will not heat up

If the sauna heater will not heat up, please check that:
1. The power is on; And the heater main switch is in position I (close to the thermostat dial)
2. The timer is on the heating zone (operating zone);
3. The thermostat is switched to a temperature that is higher than the current temperature of the sauna room;
4. The front fuses of the sauna heater are intact;
5. The timer is not stuck. Make sure the knob doesn't chafe against the base; there should be min 1mm gap
between the knob and the base.
If the sauna heater has been exposed to freezing conditions, the temperature limiter may have gone off. The limiter is reset
by pressing the reset switch. Note that the limiter does not work until the temperature has risen to approx. -5°C. If the sau-
na heater still fails to work, please contact an authorised service for repair.
THE PERSON INSTALLING THE SAUNA HEATER SHOULD LEAVE THESE INSTRUCTIONS AT THE PREMISES
FOR THE FUTURE USER.
6
PALAUT US RETUR RESETTING
+