IKEA MIRAKULÖS Handbuch Seite 19

ENGLISH
Stainless steel or aluminium appliances
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean
the oven control panel with the
same precautions.
Removing the shelf supports
To clean the oven, remove the shelf
supports.
1
Pull the front of the
shelf support away
from the side wall.
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point to
the front.
Pyrolysis
Caution! Remove all accessories
and removable shelf supports.
Do not let the removable shelf
supports stay in the appliance
during the cleaning procedure.
There is a risk of damage.
2
2
1
Pull the rear end of
the shelf support
away from the side
wall and remove it.
Warning! The appliance
becomes very hot. There is a risk
of burns.
Do not start the Pyrolysis if you
did not fully close the oven door.
Caution! Do not use the hob at
the same time as the Pyrolysis
function. It can cause damage to
the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
4. When the display shows P1, press
start the procedure.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
Time of the procedure: 1 h 30
min.
Do not open the door before the
procedure completes. This will
abort the procedure. To prevent
risk of burns when the oven
reaches a certain temperature
the door automatically locks. The
display shows the symbol
When the oven cools down, the
door automatically unlocks.
To stop Pyrolysis before it is
completed, turn the knob for the
oven functions to the off position.
When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again,
an acoustic signal sounds and the door
unlocks.
19
to
.