Dispensing Hot Water - Wega io EVD Bedienungs- Und Wartungsanleitung

Dispensing hot water

6.10
6.10.1 1GR Version
• Place the jug
under the hot
15
water nozzle (3);
• turn the water
6
knob (15) coun-
ter-clockwise;
• t o i n t e r r u p t
3
steam dispens-
ing turn the wa-
ter k nob (15)
clockwise.
6.10.2 2-3GR Version
• Place the pot under the hot
water spout;
• Press the water button
and wait for the hot water to be
dispensed;
• To stop the water dispensing
ahead of time, press either the
hot water dispensing button
again .
To programme the hot water, see chapter "7.2 Hot water (2-3GR
Version)" on page 42.
Avoid contact with the hot water nozzle, do not place your hands
or other body parts near the hot water nozzle tips.
User manual
7.
PROGRAMMING
The machine is programmed by default. Should the
settings need to be modified, proceed as described in
the following paragraphs:
Coffee doses
7.1
• Always programme the right push-button panel first.
This way, both push-button panels are automatically
programmed. If necessary, programme the left later;
• place the cup under the dis-
pensing spout;
• press the STOP/PROG. button
for at least 5 seconds until the
STOP/PROG. button flashes;
• press the desired dose button,
for example ;
• to confirm the dose, press the
button again;
• repeat this operation for the
other dose buttons;
• when the programming is com-
plete, press the STOP/PROG.
button until all of the LEDs on
the push-button panel are lit.
The programming of every dose must be carried out with ground
coffee and not with previously used coffee dregs.
The system automatically exits the programming mode 20 seconds
after the last operation was carried out.
Do not remove the filter holder from the dispensing group when
coffee is being dispensed.
Do not insert your fingers or any other objects into the filter holder.
41