JVC KW-AVX810 Bedienungsanleitung Seite 65

Equalizer
Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/User1/User2/User3 ☞ [57]
Sound
Menu items
Fader/Balance
Fader/Balance
Fader
Balance 0
Back
5
Volume Adjust *
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain
5
* For digital sources: you can make the adjustments separately depending on the audio format—Dolby Digital/DTS
and the others.
Selectable settings, [reference page]
Adjust fader—speaker output balance between the front and rear speakers.
• Upmost—front only (F6)
Reset
• Downmost—rear only (R6)
0
When using a two-speaker system, set the fader to the center (0).
Adjust balance—speaker output balance between the left and right speakers.
• Leftmost—left only (L6)
Exit
• Rightmost—right only (R6) Initial 0
Adjust and store auto-adjustment volume level for each source, comparing to
the FM volume level. The volume level will automatically increase or decrease
when you change the source.
–12 to +12; Initial 00
Adjust the subwoofer output level. Level: –06 to +08; Initial 00
Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
Off: Deactivates the built-in amplifier.
Low: VOL 00 to 30 (Select this if the maximum power of the speakers is less
than 50 W.)
High: VOL 00 to 50
The procedure for setting an item is shown on page 59.
65
SETTINGS