Charging Batteries; Selecting A Display Language; Registering The Handset For The First Time - Auerswald COMfortel M-520 Betriebsanleitung

Initial Commissioning

Charging Batteries

When supplied, the rechargeable battery is partially charged.
• Before you use the handset for the first time,
put it in the charging cradle and fully charge
the rechargeable battery.
The rechargeable battery is fully charged
when the lighting flash symbol
Caution: The handset must be charged in the charging cradle supplied
with it!
Note: The rechargeable battery might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable battery reduces over time.

Selecting a Display Language

The language setting display is displayed. The set
language (e. g. English) is marked (
1. Press until the required language, e.g. Français,
is marked in the display.
2. Press the right-hand key directly under the display to activate the language.
3. Exiting the menu: Press
If you need to display the menu again, do this:
1. Press the middle of the control key
2. Slowly press

Registering the Handset for the First Time

These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
• The handset has been configured in the base station
• Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI in the battery compartment and
on the packaging label or scan it in. Alternatively, you can view the IPUI
on the display. To do so, press the centre of the control key
34
goes out in the display.
for a long time.
and , one after the other.
COMfortel M-520 - Instructions V04 09/2021
Deutsch
= selected).
English
Français
.
to display