Electrolux 7000 service Bedienungsanleitung Seite 19

Problem/alarm code
The remaining time in the dis-
play increases and skips
nearly to the end of pro-
gramme time.
The appliance door is difficult
to close.
Rattling/knocking sounds
from inside the appliance.
The appliance trips the cir-
cuit-beaker.
The appliance does not fill
with water.
The display shows the alarm
code .
The appliance does not drain
the water.
The display shows the alarm
code .
The anti-flood device is on.
The display shows the alarm
code .
Once the controls have been done,
deactivate the appliance and wait 5 minutes
before activating it again. If the problem
persists or the alarm code continues to
appear, contact an Authorised Service
Centre.
When you contact the Service
Centre always remember to give
the alarm code (when available).
Poor washing results
• The baskets have been overloaded.
Possible solution
• This is not a defect. The appliance is working correctly.
• Parts of the tableware are protruding from the baskets (e.g.
pot or pan handles, ladles).
• The tableware is not properly arranged in the baskets, items
are touching each other.
• One or both spray arms are touching the tableware while
turning. Make sure that the spray arms can rotate freely oth-
erwise the cleaning results will be heavily affected.
• The amperage is insufficient to supply simultaneously all the
appliances in use. Check the socket amperage and the ca-
pacity of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Author-
ised Service Centre.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service Cen-
tre.
• Tableware has not been properly
arranged.
• The quantity of detergent was not
enough.
• The detergent was not suitable or old.
• The programme was not appropriate for
the degree of soil and the type of load.
• The spray arms were blocked by the
tableware and could not rotate freely.
• The spray arms are clogged.
• The filters are clogged or not positioned
correctly.
19