Electrolux 7000 service Bedienungsanleitung Seite 13

Using the detergent
A B
30
20
CAUTION! Only use detergent
specifically designed for
dishwashers.
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the release
button locks into position.
Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode.
C
3. Press
or
the indicator of the programme you
want to select comes on.
The programme duration flashes in the
display.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme duration stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The delay time flashes in the display.
3. Close the appliance door to start the
countdown.
The delay time stops flashing and comes
on with fixed light.
• When the countdown is completed, the
programme starts.
• While the countdown is running only the
buttons Reset and Delay are active. It is
not possible to change the programme
or options.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold Reset until the appliance is
in programme selection mode.
again and again until
13