Internal Cleaning; Troubleshooting; Technical Problems - Electrolux 7000 service Bedienungsanleitung

18

Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
damp cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.

TROUBLESHOOTING

The vast majority of problems that can
occur during daily operation can be
easily solved without the need to con-
tact an Authorised Service Centre and
will save time and money.
In this chapter we will help you to recog-
nize and solve these problems.

Technical problems

Problem/alarm code
You cannot activate the ap-
pliance.
The programme does not
start or stops during opera-
tion.
The appliance stops and
starts more times during op-
eration.
The programme lasts too
long.
• To maintain the performance of your
appliance at its best, we recommend to
use monthly a specific cleaning product
for dishwashers. Follow carefully the
instructions on the packaging of the
product.
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the delay setting or wait for
the end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
• It is normal that the appliance stops and starts during the
programme in order to provide optimal cleaning results and
energy savings.
• In models with the ''water sensor'' you will hear more stops
and starts during the programme. This depends on the se-
lected programme and the level of soil sensed.
• An energy-saving programme has been selected, in this
case the total programme time increases to compensate the
lower washing and drying temperatures. Use these pro-
grammes preferably at night.
• If the delay start is set, cancel the delay setting or wait for
the end of the countdown.
WARNING! Repairs not
properly done may result in
serious risk to the safety of the
user. Any repairs must be
performed by qualified
personnel.