Maintenance And Cleaning; Cleaning And Maintenance - tepro MILWAUKEE Bedienungsanleitung

t

Maintenance and Cleaning

Your grill is made of high-quality materi-
als. To clean and maintain the surfaces,
please heed the following instructions:
Danger Risk of burning!
Let the grill cool down complete-
ly before cleaning.
– Empty the ashes once the fuel has
burned down completely and is out.
Danger Health hazard!
Do not use any paint solvents or
thinners to remove stains. Such
liquids are hazardous to health
and may not come into contact
with food.
Attention Risk of damage!
Do not use any strong or abrasive
solvents or scouring pads as
such products attack the grill's
surfaces and leave permanent
markings.
• Let the fuel burn out completely after
grilling. This makes the cleaning easier
as any excess fat and barbecue resi-
dues burn away.
• Empty out the cold ash and clean the
grill regularly, preferably after every
use. It is very important that you
remove the ash from the grill body
before any moisture combines with
the cold ash. Ash is saline and, in
a moist condition, it will damage
the inside of the grill body. If this
happens regularly over years, the
grill body can sustain damage
through rust.
34
P180143-TEPRO-1049-Milwaukee-Smoker_GB_20180720.indb 34
All manuals and user guides at all-guides.com
• Remove the cooking grate and clean
• Rub the cooking grates and the char-
• Use a wet sponge to remove loose res-
• Use a soft, clean cloth for drying. Do
• Clean the inner and outer surfaces with
• Tighten all bolts before every use to
• Protect the grill from ongoing weather
• NOTE: Your grill will develop a patina
• IMPORTANT: Always store the grill in
it thoroughly with soapy water. Wash it
with clean water and then dry the grate
carefully.
coal grates with vegetable oil (a thin
layer) after cleaning.
idue from the grill.
not scratch the surfaces when wiping
them dry.
warm soapy water as a general prac-
tice.
ensure that the grill stands stable at all
times.
effects. Since it has been made of
steel, it will one day develop some cor-
rosion. If this happens, rub the rusty
spots clean and cover them with a
heat-resistant paint.
after some time of use. If you do not
like this rusty look, you can proceed as
follows: Remove the rust using a wire
brush or a rust removing gel. Then
apply an oven lacquer to the surface
(heat resistant to at least 600°C). Then
your smoker will look like new again.
a dry place, protected from moisture.
20/7/2018 3:59 PM